Log; Save As; Troubleshooting Applock - LXE MX8 Reference Manual

220

Log

Note:
In addition to the three view levels the administrator can select that all status information be
logged or turn off all status information logging completely. The system default is 'None';
however to reduce registry use, the administrator may want to select 'None' after verifying the
configuration. Tap the Clear button to clear the status information from the registry.
• None (default)
• Error
• Processing
• Extended
• All

Save As

When the 'Save As'... button is selected, a standard 'Save As' dialog screen is displayed. Specify
the path and filename. If the filename exists, the user is prompted whether the file should be
overwritten. If the file does not exist, it is created.

Troubleshooting AppLock

The mobile device won't switch from Administration mode to end-user mode.
If two copies of the same application are configured, but the application only allows one copy to
run at a time, for example Microsoft Pocket Word, the switch to end-user fails. AppLock stays in
Administration mode and is stopped until the Administrator password is entered.
The hotkey sequence needed is not allowed. What does this mean?
When the Administrator is selecting a hotkey sequence to use when switching user modes, they
are not allowed to enter key combinations that are reserved by installed software applications.
LXE has validated RFTerm key combinations ONLY.
When RFTerm is installed on the mobile device and an RFTerm restricted key sequence is
specified as a hotkey sequence by the Administrator, the following error message is displayed in a
message box:
When RFTerm is not installed on the mobile device, the RFTerm keys are not restricted from use.
MX8 Reference Guide
If a level higher than Error is selected, the status should be cleared frequently by the
administrator.
Selected hotkey is not allowed. Please reenter.
Multi-Application Configuration
E-EQ-MX8RG-A