LXE MX8 Reference Manual page 241

Error Messages
Message
Registry read failure at reenter user
mode
Registry read failure at reenter user
mode
Registry read failure
Reset system work area failure
Shift pressed
Shift
Show taskbar
Switching to admin-backdoor
Switching to admin-hotkey press
Switching to admin-kbdhook.dll not
found
Switching to admin-keyboard hook
initialization failure
Switching to admin-registry read
failure
Switching to TaskbarScreenMode
E-EQ-MX8RG-A
Explanation and/or corrective action
The registry has to be read when entering user mode is
the AppName is missing. This user mode entry is
attempted at boot and after a hotkey switch when the
administrator has closed the application being locked or
has changed the application name or command line.
The registry has to be read when switching into user
mode. This is because the administrator can change the
settings during administration mode. The read of the
registry failed which means the Administration key was
not found or the AppName value was missing or empty.
The registry read failed. The registry information read
when this message is logged is the application
information. It the Administration key cannot be opened
or if the AppName value is missing or empty, this error
is logged. The other application information is not
required. If the AppName value is not available,
AppLock cannot switch into user mode.
The system work area is adjusted when in user mode to
cover the taskbar area. The system work area has to be
adjusted to exclude the taskbar area in administration
mode. AppLock was unable to adjust this area.
The Shift key has been pressed and trapped by the
HotKey processing.
Processing the hotkey and backdoor entry
The taskbar is now being made visible and enabled.
The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of the backdoor key presses were entered by the
administrator.
The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of a hotkey press by the administrator.
The keyboard hook load failed, so AppLock switches to
admin mode. If a password is specified, the password
prompt is displayed and remains until a valid password
is entered.
If the keyboard hook initialization fails, AppLock
switches to admin mode. . If a password is specified,
the password prompt is displayed and remains until a
valid password is entered.
See the explanation of the "Registry read failure" above.
AppLock is switching into Admin mode. If a password
has been configured, the prompt will be displayed and
will not be dismissed until a valid password is entered.
In administration mode, the taskbar is visible and
enabled.
227
Level
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_PROCESSING
LOG_PROCESSING
LOG_PROCESSING
LOG_PROCESSING
LOG_PROCESSING
LOG_PROCESSING
LOG_EX
MX8 Reference Guide