Main Tab - LXE MX8 Reference Manual

146

Main Tab

Access:
Factory Default Settings
Main
Port 1
Port 2
Port 3
Send key messages (WEDGE)
Enable Internal Scanner Sound
Use Illumination LEDs
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
Parameter
Port
Send Key Messages
(WEDGE)
Enable Internal
Scanner Sound
Use Illumination
LEDs
MX8 Reference Guide
| Settings | Control Panel | Scanner | Main tab
Internal
Disabled
Disabled
Enabled
Enabled
Enabled
Figure 4-2 Scanner Control / Main
Function
Port 1 – Internal. Radio button allows scanner input/output on Port 1
(scan key or trigger).
Port 2 – Output is enabled when COM1 is enabled on this port.
Port 3 - Output is enabled when COM1 is enabled on this port.
When Send Key Messages (WEDGE) is checked any data scan is
converted to keystrokes and sent to the active window. When this box is
not checked, the application will need to use the set of LXE Scanner
APIs to retrieve the data from the scanner driver. Note that this latter
method is significantly faster than using "Wedge".
The default is Enabled. Functionality of the internal scanner driver
engine includes audible tones on good scan (at the maximum db
supported by the speaker) and failed scan. If enabled, Good Scan / Bad
Scan Vibration provides a tactile response on a scan event.
Disable this parameter when good scan/bad scan sounds are to be
handled by alternate means e.g. application-controlled sound files.
Rejected barcodes generate a bad scan beep. In some cases, the receipt
of data from the scanner triggers a good scan beep from an external
scanner, and then the rejection of scanned barcode data by the
processing causes a bad scan beep from the MX8 on the same data.
The default setting is Enabled. Integrated imager may use illumination
LEDs when scanning a barcode.
Main Tab
E-EQ-MX8RG-A