Bluetooth Barcode Reader Setup; Introduction; Figure 1-26 Sample Bluetooth Address Barcode Label - LXE MX8 Reference Manual

Bluetooth

Bluetooth Barcode Reader Setup

Please refer to the Bluetooth scanner manufacturer's User Guide; it may be available on the
manufacturer's web site. Contact your LXE representative for Bluetooth product assistance.

Introduction

LXE supports several different types of barcode readers. This section describes the interaction and
setup for a mobile Bluetooth laser scanner or laser imager connected to the MX8 using Bluetooth
functions.
• The MX8 must have the Bluetooth hardware and software installed. An MX8 operating system
upgrade may be required. Contact your LXE representative for details.
• If the MX8 has a Bluetooth address identifier barcode label affixed, then Bluetooth hardware
and software is installed.
• The mobile Bluetooth laser scanner / laser imager battery is fully charged.
• The MX8 batteries are fully charged. Alternatively, the MX8 may be cabled to AC/DC power.
• The barcode numbering examples in this segment are not real and should not be created nor
scanned with a Bluetooth scanner.
• To open the LXEZ Pairing program, tap Start | Settings | Control Panel | Bluetooth or tap the
Bluetooth icon on the desktop or tap the Bluetooth icon in the taskbar.
Locate the barcode label, similar to the one shown above, attached to the mobile device. The label
is the Bluetooth address identifier for the MX8.
The mobile Bluetooth scanner / imager requires this information before discovering, pairing,
connecting or disconnecting can occur.
Important: The MX8 Bluetooth address identifier label should remain protected from damage
(rips, tears, spills, soiling, erasure, etc.) at all times. It may be required when pairing, connecting,
and disconnecting new Bluetooth barcode readers.
E-EQ-MX8RG-A
LnkB00440fd01020 - Sample

Figure 1-26 Sample Bluetooth Address Barcode Label

33
MX8 Reference Guide