Barcode Tab; Buttons - LXE MX8 Reference Manual

148

Barcode Tab

Access:
The Scanner application (Wedge) can only enable or disable the processing of a barcode inside the
Wedge software.
The Scanner application enables or disables the Code ID that may be scanned.
Enabling or disabling a specific barcode symbology is done manually using the configuration
barcode in the Integrated Scanner Programming Guide (available on the LXE Manuals CD and
the LXE ServicePass website).
Choose an option in the Enable Code ID drop-down box: None, AIM ID, Symbol ID, or Custom
ID.

Buttons

Symbology
Settings
Ctrl Char
Mapping
Custom
Identifiers
See Also: Barcode Processing Overview earlier in this chapter.
MX8 Reference Guide
| Settings | Control Panel | Scanner | Barcode tab
Figure 4-4 Scanner Control / Barcode tab
Individually enable or disable a barcode from being scanned, set the minimum
and maximum size barcode to accept, strip Code ID, strip data from the
beginning or end of a barcode, or (based on configurable Barcode Data) add a
prefix or suffix to a barcode before transmission.
Define the operations the LXE Wedge performs on control characters (values
less than 0x20) embedded in barcodes.
Defines an identifier that is at the beginning of barcode data which acts as a
Code ID. After a Custom Identifier is defined, Symbology Settings can be
defined for the identifier just like standard Code IDs.
Barcode Tab
E-EQ-MX8RG-A