Suspend Mode; The Mx8; Off Mode; Bluetooth Lxez Pairing - LXE MX8 Reference Manual

52

Suspend Mode

The MX8

The Suspend mode is entered when the unit is inactive for a predetermined period of time or the
user taps the Power key.
MX8 Suspend timers are set using
A Power key tap wakes the unit and resets the display backlight timers. Wake up sources can be
configured by the administrator, e.g.; any key press, a trigger press, a touchscreen tap, AC adapter
insert, USB cable insert, or Serial cable CTS will also wake the unit and reset the display
backlight timers.
When the unit wakes up, the Display Backlight and the Power Off timers begin the countdown
again.
The MX8 should be placed in Suspend mode before hot swapping the main battery.

Off Mode

The unit is in Off Mode when the main battery and the backup battery are depleted. Insert a fully
charged main battery and press the Power key to turn the MX8 On.

Bluetooth LXEZ Pairing

The MX8 contains Bluetooth version 2.0 with Enhanced Data Rate (EDR) up to 3.0 Mbit/s over
the air. Bluetooth device connection (or pairing) can occur at distances up to 32.8 ft (10 meters)
Line of Sight. The wireless client retains network connectivity while Bluetooth is active.
The user will not be able to select PIN authentication or encryption on connections from the MX8.
However, the MX8 supports authentication requests from pairing devices. If a pairing device
requests authentication or encryption, the MX8 displays a prompt for the PIN or passcode.
Maximum encryption is 128 bit. Encryption is based on the length of the user's passcode.
Bluetooth will simultaneously support one printer as a slave Bluetooth device and one scanner,
either as a slave or as a master Bluetooth device.
See Chapter 3 System Configuration, control panel section titled Bluetooth.
Notes
•
The MX8 does not have a Bluetooth managed LED.
•
The LED on the Bluetooth scanner illuminates during a scanning operation; the Scan LED
on the MX8 does not illuminate.
•
Barcode data captured by the Bluetooth scanner is manipulated by the settings in the MX8
Scanner Properties control panel applet.
•
Multiple beeps may be heard during a barcode scan using the Bluetooth scanner; beeps
from the Bluetooth scanner as the barcode data is accepted/rejected, and other beeps from
the MX8 during final barcode data manipulation.
MX8 Reference Guide
| Settings | Control Panel | Power | Schemes tab.
Bluetooth LXEZ Pairing
E-EQ-MX8RG-A