Touchscreen; Display Backlight Timer; Cleaning The Display/Scanner Aperture - LXE MX8 Reference Manual

Touchscreen

Touchscreen
The touchscreen display is an active color LCD unit capable of supporting VGA graphics modes.
Display size is 240 x 320 pixels in portrait orientation. The covering is designed to resist stains.
The touchscreen allows signature capture and touch input. A pen stylus is included with the
handstrap and the trigger handle. The touchscreen responds to an actuation force (touch) of 4 oz.
of pressure (or greater).
The color display is optimized for indoor lighting. The display is black when the device is in
suspend mode or when both batteries have expired and the unit is Off.

Display Backlight Timer

When the Backlight timer expires the display backlight is dimmed.
The default value for the battery power timer is 3 seconds. The default value for the external
power timer is 2 minutes and the checkbox is enabled.
The backlight timer dims the backlight on the touchscreen at the end of the specified time. When
the display wakes up, the Backlight timer begins the countdown again.
See the section titled Set the Display Backlight Timer in Chapter 1 – Introduction.

Cleaning the Display/Scanner Aperture

If there is a static screen protector installed, remove the screen protector before cleaning the
display panel.
Keep fingers and rough or sharp objects away from the scan aperture and display. If the scanner
aperture or display become soiled or smudged, clean only with a standard household cleaner such
as Windex(R) without vinegar or use Isopropyl Alcohol. Do not use paper towels or harsh-
chemical-based cleaning fluids since they may result in damage to the surface. Use a clean, damp,
lint-free cloth. Do not scrub optical surfaces. If possible, clean only those areas which are soiled.
Lint/particulates can be removed with clean, filtered canned air.
Static screen protectors for the MX8 are available from LXE.
E-EQ-MX8RG-A
Figure 2-8 Touchscreen
59
MX8 Reference Guide