Set The Mx8 Power Schemes Timers - LXE MX8 Reference Manual

Software Setup

Set the MX8 Power Schemes Timers

Note:
Select
OK to save the changes.
Battery Power Scheme
Use this option when the MX8 will be running on battery power only.
Switch state to User Idle:
Switch state to System Idle:
Switch state to Suspend:
AC Power Scheme
Use this option when the MX8 will be running on external power.
Switch state to User Idle:
Switch state to System Idle:
Switch state to Suspend:
These mode timers are cumulative. The System Idle timer begins the countdown after the User
Idle timer has expired and the Suspend timer begins the countdown after the System Idle timer has
expired. When the User Idle timer is set to "Never", the power scheme timers never place the
device in User Idle, System Idle or Suspend modes (even when the device is idle).
Because of the cumulative effect, and using the Battery Power Scheme defaults listed above:
• The backlight turns off after 3 seconds of no activity,
• The display turns off after 18 seconds of no activity (15sec + 3sec),
• And the device enters Suspend after 5 minutes and 18 seconds of no activity.
E-EQ-MX8RG-A
Refer to the section titled "Power Modes" later in this guide for information relating to
the power states of the MX8.
| Settings | Control Panel | Power | Schemes tab. Change the parameter values and tap
Default is After 3 seconds
Default is After 15 seconds
Default is After 5 minutes
Default is After 2 minute
Default is After 2 minutes
Default is After 5 minutes
MX8 Reference Guide
23