Regload.exe; Wavelink Avalanche Enabler Configuration; Briefly; Enabler Install Process - LXE MX8 Reference Manual

Wavelink Avalanche Enabler Configuration

RegLoad.EXE

Double-tapping a registry settings file (e.g. .REG) causes RegLoad to open the file and make the
indicated settings in the registry. This is similar to how RegEdit works on a desktop PC. The .REG
file format is the same as on the desktop PC.
Wavelink Avalanche Enabler Configuration
If the user is NOT using Wavelink Avalanche to manage their mobile device, the Enabler
should not be installed on the mobile device.

Briefly . . .

The Wavelink Avalanche Enabler installation file is loaded on the mobile device by LXE;
however, the device is not configured to launch the installation file automatically. The installation
application must be run manually the first time Avalanche is used. After the installation
application is manually run, a reboot is necessary for the Enabler to begin normal performance.
Following this reboot, the Enabler will by default be an auto-launch application. This behavior can
be modified by accessing the Avalanche Update Settings panel through the Enabler Interface.
Note:

Enabler Install Process

• Doubletap the Avalanche Enabler CAB file in the System folder. The filename is
LXE_MX8_ENABLER.CAB.
• Warm boot the mobile device.

Enabler Uninstall Process

To remove the LXE Avalanche Enabler from a Windows CE mobile device:
• Delete the Avalanche folder located in the System folder.
• Warm boot the mobile device.
The Avalanche folder cannot be deleted while the Enabler is running. See Stop the Enabler
Service. If sharing errors occur while attempting to delete the Avalanche folder, warm boot the
mobile device, immediately delete the Avalanche folder, and then perform another warm boot.
Orphaned Packages
To prevent the enabler from restoring parameters, delete orphaned packages through the
Avalanche Mobility Center (refer to the Wavelink Avalanche Mobility Center User's Guide for
details and instruction).
E-EQ-MX8RG-A
On LXE mobile devices with integrated scanners, the Scanner Wedge has primary
control of the serial ports and must be configured properly to allow the Enabler to access
the serial ports.
125
MX8 Reference Guide