Configuring Snmp Trap Receivers - Motorola RFS7000 Series System Reference Manual

7.5 Configuring SNMP Trap Receivers

Refer to the Trap Receivers
destination address, port, community, retry count, timeout and trap version). A new v2c or v3 trap receiver can
be added to the existing list by clicking the
To configure the attributes of SNMP trap receivers:
1. Select Management Access > SNMP Trap Receivers
2. Refer to the following SNMP trap receiver data to assess whether modifications are required.
Destination Address
Port
Community String/
User Name
Trap Version
3. Highlight an existing Trap Receiver and click the
the v2c or v3 Trap Receiver.
Edit Trap Receivers as needed if existing trap receiver information is insufficient. You can only modify
the IP address, port and v2c or v3 trap designation within the Edit screen. For more information, see
Editing SNMP Trap Receivers on page
4. Highlight an existing Trap Receiver and click the
list of available destinations available to receive SNMP trap information.
screen to review the attributes of existing SNMP trap receivers (including
Add button.
The Destination Address
destination IP address for receiving traps sent by the SNMP agent.
The Port specifies a destination User Datagram Protocol
(UDP) receiving traps.
Enter a Community name specific to the SNMP-capable client that
receives the traps. The community name is public.
The Trap Version defines the trap version (v1/2 or v3) defined by
the SNMP-capable client receiving the trap. A trap designation
cannot be modified.
7-18.
Switch Management
from the main menu tree.
defines the numerical (non DNS name)
Edit button to display a sub-screen used to modify
Delete button to remove the Trap Receiver from the
7-17