Viewing And Configuring Port Instance Details - Motorola RFS7000 Series System Reference Manual

Port Path Cost
Admin Point-to-Point
status
Port Enable
Port Migration
Admin Edge Port
2. Click on OK button to save and commit the new configuration.
3. Click Cancel to disregard the changes and revert back to the previous configuration.

4.10.4 Viewing and Configuring Port Instance Details

Use the Port Instance tab to view and configure MST port instance parameters, including Port Priority and
Admin Internal Path Cost.
To view and configure the MSTP bridge instance:
1. Select Network > Multiple Spanning Tree
Define the path cost for the specified port index. The cost is 1,000
Mbps (1 gigabit per second) divided by the bandwidth of the
segment connected to the port. Therefore, a 10 Mbps connection
would have a cost of (1,000/10) 100.
Define the point-to-point status as ForceTrue or ForceFalse.
ForceTrue indicates this port should be treated as connected to a
point-to-point link. ForceFalse indicates this port should be treated
as having a shared connection.
Select this checkbox to use this port for the forwarding of MST
supported packets on the switch.
If enabled, protocol migration enables the switch (when running
MST) to interoperate with legacy 802.1d switches. If the listed
index receives a legacy 802.1D configuration BPDU, it only sends
802.1D BPDUs over its port.
Select the checkbox to define this port index as an admin edge port.
from the main menu tree.
4-131
Network Setup