Motorola RFS7000 Series System Reference Manual page 456

B - 12 RFS7000 Series Switch System Reference Guide
B.4.1 Adaptive AP Configuration
An AAP can be manually adopted by the switch, adopted using a configuration file (consisting of the
adaptive parameters) pushed to the access point or adopted using DHCP options. Each of these
adoption techniques is described in the sections that follow.
B.4.1.1 Adopting an Adaptive AP Manually
To manually enable the access point's switch discovery method and connection medium required for
adoption:
1. Select
2. Select the
Enabling auto discovery will allow the AAP to be detected by a switch once its connectivity
medium has been configured (by completing steps 3-6).
3. Enter up to 12
connection.
The AAP will begin establishing a connection with the first addresses in the list. If
unsuccessful, the AP will continue down the list (in order) until a connection is established.
4. If a numerical IP address is unknown, but you know a switch's fully qualified domain name
(FQDN), enter the name as the
System Configuration -> Adaptive AP Setup
Auto Discovery Enable
NOTE Auto discovery must be enabled for a switch to detect an AP.
Switch IP Addresses
Switch FQDN
from the access point's menu tree.
checkbox.
constituting the target switches available for AAP
value.