Approved Aps (Reported By Aps) - Motorola RFS7000 Series System Reference Manual

6.2.2 Approved APs (Reported by APs)

Those access points detected and approved for operation within the switch managed network can be
separately displayed to assess the reporting (detecting) AP, the channel of operation, the last time the AP was
observed on the network and the ESSID. Use this information to assess if an approved access point was
incorrectly defined as approved and requires categorization as an unapproved and disallowed AP.
To review the attributes of allowed APs:
1. Select Security >
2. Select the Approved APs (Reported by APs)
3. The Approved APs (Reported by APs)
BSS MAC Address
Reporting AP
Channel
Last Seen (In Seconds) Displays the time (in seconds) the approved AP was last seen on
ESSID
4. The Number of Approved APs
detected.
Access Port Intrusion Detection
table displays the following information:
Displays the MAC Address of each approved AP. These MAC
addresses are access points observed on the network meeting the
criteria (MAC and ESSIDs) of allowed APs.
Displays the numerical value for the radio used with the specific
device MAC Address and SSID listed for this approved AP.
Displays the channel the approved AP is currently transmitting on.
If this device is operating on a channel not frequently used within
your network segment, perhaps the device is correctly defined as
an approved AP.
the network.
Displays the SSID of each approved AP.
is simply the sum of all of approved access point MAC Addresses
from the main menu.
tab.
6-7
Switch Security