Motorola RFS7000 Series System Reference Manual page 268

5-48 Switch Services
The Layer 3 Mobility
2. Select the Use Default Management Interface
interface IP address for MUs roaming amongst different Layer 3 subnets. The IP address displayed to
the right of the checkbox is used by Layer 3 MU traffic.
3. If wanting to use a local IP addresses (non switch management interface) for MUs roaming amongst
different Layer 3 subnets, select the
4. Use the Roam Interval
allowed to roam amongst different subnets.
5. Refer to the table of WLANs and select the checkboxes of those WLANs you wish to enable Layer 3
mobility for.
Once the settings are applied, MUs within these WLANs can roam amongst different subnets.
6. Select the Enable Mobility
roaming throughout a multi-VLAN network.
7. Select the All WLANs On
If unsure if you want to enable mobility for each WLAN, manually select just those you want to
enable.
8. Select the All WLANs Off
9. Click the Apply button to save the changes made within this screen. Clicking Apply overwrites the
previous configuration.
10. Click the Revert button to disregard any changes made within this screen and revert back to the last
saved configuration.
screen appears with the Configuration tab displayed.
Use this Local Address
to define the maximum length of time MUs within selected WLAN are
checkbox to enable a MU to maintain the same Layer 3 address while
button to enable mobility for each WLAN listed.
button to disable mobility for each WLAN listed.
checkbox to use the switch's default management
checkbox and enter an IP address.