Motorola RFS7000 Series System Reference Manual page 382

6-98 Switch Security
4. Use Scan Interval value to enter the interval used by the radio between scans. The radio scans each
channel for the defined interval. The default value is 10 seconds.
5. Use the Scan Time
defined interval. The default value is 100 milliseconds.
6. Use the Max Number of APs
Found table. The available range is from 0 to 512.
7. Refer to 802.11a Channel Set
channel information is provided to the switch, which then makes an 802.11a radio scan for the
configured channels.
Allowed
Add ->
<- Remove
Configured
Enable all
Disable all
8. Refer to 802.11bg Channel Set
channel information is provided to the switch, which conducts an 802.11bg scan for each channel.
Allowed
Add ->
<- Remove
Configured
value to enter the duration of the scan. The radio scans each channel for the
value to configure the number of detected APs displayed in the Beacon
field to select channels for the 802.11a transmission band. The
Displays all the channels available to the AP. The channel list is country specific
and differs from country to country.
Select a channel frequency and click the
the Configured list box. You can select multiple channels and add them to the
Configured list box. Press the Ctrl button and use the mouse to select multiple
channels. The switch uses an 802.11a radio to scan the selected channels to
detect any rogue AP's.
Select the channel's frequency from the Configured list box and click
to remove a channel from the list of channels provided to the switch.
Displays the channels provided to the switch. The switch makes all the 802.11a
radios move to a channel from this channel-set and scan these channels, one at a
time, for a configurable duration.
Select the Enable all button (within the 802.11a Radios field) to enable all
802.11a radios from receive beacons.
Select the Disable all button (within the 802.11a Radios field) to disable all
802.11a radios from receiving beacons.
field to select channels for the 802.11bg transmission band. The
Displays all the channels available to the AP. The channel list is country specific
and differs from country to country.
Select a channel frequency and click the
the Configured list box. Select multiple channels and add them to the
Configured list box. Press the Ctrl button and use the mouse to select multiple
channels. The switch uses an 802.11a radio to scan the selected channels to
detect any non-adopted or rogue AP's.
Select the channel's frequency from the Configured list box and click
to remove a channel from the list of channels provided to the switch.
Displays the channels provided to the switch. The switch makes all the 802.11bg
radios move to a channel from this channel-set and scan these channels, one at a
time, for a configurable duration.
Add -> button to include the channel to
<- Remove
Add -> button to include the channel to
<- Remove