Adding A Virtual Interface - Motorola RFS7000 Series System Reference Manual

Management
Interface
The Associated Secondary IP Addresses
available, but designated as secondary and not immediately used unless the primary designations
become unavailable.
3. Select a record from the table and click the
see Modifying a Virtual Interface on page
4. Select a record from the table and click the
of switch virtual interfaces.
5. Click the Add button to add a new configuration to the switch virtual interface. For more information,
see Adding a Virtual Interface on page
6. Select an interface as click the
switch is booted.
7. Select an interface as click the

4.4.1.1 Adding a Virtual Interface

To add a new virtual interface for the switch:
1. Select Network
2. Select the Configuration
3. Click the Add button.
4. Enter the VLAN ID
A green checkmark within this column defines this VLAN as
currently used by the switch. This designates the interface settings
used for global switch settings in case of conflicts. For example, if
multiple SVIs are configured with DHCP enabled on each, the
switch could have multiple domain names assigned from different
DHCP servers The one assigned over the selected Management
Interface would be the only one used by the switch. This setting
does not affect any of the Management Access Interfaces
configured in Configuring Access Control on page
4-16.
4-15.
Startup button to invoke the selected interface the next time the
Shutdown button to disable the selected interface.
> Switch Virtual Interface
tab
for the switch virtual interface.
field displays additional IP and subnet resources
Edit button to modify the record. For more information,
Delete button to remove the configuration from the list
from the main tree menu.
4-15
Network Setup
7-3.