Motorola RFS7000 Series System Reference Manual page 79
Rf switch
Hide thumbs
Also See for RFS7000 Series:
- Reference manual (732 pages) ,
- Troubleshooting manual (60 pages) ,
- Installation manual (31 pages)
Table of Contents
Advertisement
2. Refer to the
Switch Configuration
configuration file updates. If enabled, the located (updated) configuration file will be used with the
switch the next time the switch boots
Enable
IP Address
User ID
Password
File Name (With Path) Provide the complete and accurate path to the location of the
Protocol/Device
Password
3. Refer to the
Redundancy Configuration
cluster file updates.
Enable
IP Address
User ID
Password
File Name (With Path) Provide the complete and accurate path to the location of the
Protocol/Device
Password
field to enable and define the configuration for automatic
Select the
Enable
checkbox to allow an automatic configuration
file update when a newer (updated) file is detected (upon the boot
of the switch) at the specified IP address.
Define the
IP address
of the server where the configuration files
reside. If a new version is detected when the switch is booted, it is
uploaded to the switch and used upon the next boot of the switch.
Enter the
User ID
required to access the FTP or HTTP server.
Enter the
Password
for the
User ID
HTTP server.
configuration files on the server. This path must be accurate to
ensure the most recent file is retrieved.
Use the
Protocol
drop-down menu to specify the Unset,
TFTP, HTTP,
FLASH,
CF, USB1, or USB2
the file update from the server. The switch's resident flash is
selected by default.
Enter the password required to access the server.
field to enable and define the configuration for automatic
Select the
Enable
checkbox to allow an automatic cluster file
update when a new (updated) file is detected (upon the boot of the
switch) at the specified IP address.
Define the
IP address
of the server where the cluster files reside.
If a new version is detected when the switch is booted it will be
uploaded to the switch and used upon the next boot of the switch.
Enter the
User ID
required to access the FTP or HTTP server.
Enter the
Password
for the
User ID
HTTP server.
cluster files on the server. This path must be accurate to ensure the
most recent file is retrieved.
Use the
Protocol
drop-down menu to specify Unset,
HTTP,
FLASH,
CF, USB1, or USB2
update from the server. The switch's resident flash is selected by
default.
Enter the password required to access the server.
Switch Information
required to access the FTP or
FTP,
as the medium used for
required to access the FTP or
FTP, TFTP,
as the medium used for the file
3-31
Advertisement
Table of Contents
