Motorola RFS7000 Series System Reference Manual page 318

6-34 Switch Security
2. Click on the Dynamic Translation
3. Refer to the following information as displayed within the
Type
Direction
Access List
tab.
Displays the NAT type as either:
• Inside - Applies NAT on packets arriving on interfaces
marked as inside. These interfaces should be private
networks not accessible from outside (public) networks.
• Outside - Applies NAT on packets coming in on interfaces
marked as outside. These switch interfaces should be
public or outside networks accessible from anywhere on
the Internet.
Displays the direction as either:
• Source - The inside network is transmitting data over the
network to its intended destination. On the way out, the
source IP address is changed in the header and replaced by
the (public) IP address.
•
Destination - Packets passing through the NAT on the way
back to the switch managed LAN are searched against the
records kept by the NAT engine. The destination IP address
is changed back to the specific internal private class IP
address to reach the LAN over the switch managed
network.
Defines the packet selection criteria for NAT. NAT is applied only
on packets which match a rule defined in the access-list. Only the
Standard IP and Extended IP Access List can be used.
Dynamic Translation tab.