Table of Contents
Advertisement
Configure Port Binding
Figure 111
176
SAN32M1 Fabric Switch Installation and Service Manual
4. Click Activate to save the information. The message Your changes
to the user rights configuration have been successfully
activated appears.
Perform this procedure to configure Fibre Channel port binding by
WWN. To configure port binding:
1. At the Configure panel, click the Port Binding tab. The Security
page displays with the Port Binding tab selected
Configure Panel (Security Page with Port Binding Tab)
a. Click the check box in the Port Binding column to enable or
disable port binding for a specified port (default is disabled).
b. In the Bound WWN column, type the world wide name of the
device to which the port is to be bound. If port binding is
enabled, only the specified device can connect to the port. If
port binding is enabled and no device is specified in the Bound
WWN column, then no devices can connect to the port.
c. The Attached WWN column contains read-only fields that list
the world wide names of attached Fibre Channel devices.
Click the check box in the Use Attached column to indicate the
world wide name specified in the Attached WWN column is to
be used for port binding. After activation, the attached WWN
appears in the Bound WWN column.
(Figure
111).
Advertisement
Table of Contents
