Table of Contents
Advertisement
Figure 75
Set date and time manually
The switch date and time can be set manually, or set to be
periodically updated by the SAN management application (the
switch and SAN management application synchronize at least
once daily).
Configure Date and Time Dialog Box
To set the switch date and time manually:
1. At the Configure Date and Time dialog box, click the Periodic
Date/Time Synchronization check box to deselect the option (no
check mark in the box). The greyed out Date and Time fields
activate.
2. Click the Date fields that require change, and type numbers in the
following ranges:
— Month (MM): 1 through 12.
— Day (DD): 1 through 31.
— Year (YY): greater than 1980.
3. Click the Time fields that require change, and type numbers in the
following ranges:
— Hour (HH): 0 through 23.
— Minute (MM): 0 through 59.
— Second (SS): 0 through 59.
4. Click Activate to set the switch date and time and close the
Configure Date and Time dialog box.
Chapter 2: Installation tasks
125
Advertisement
Table of Contents
