Tx/Rx Led (One Led Per Port) - IBM Flex System EN4023 User Manual

2
Locating the information panel, LEDs, and external ports
1
FIGURE 11
Table 5
TABLE 5
Tx/Rx LED
Off
Steady green
Flickering green
N/A
Ethernet port status LEDs
Two LEDs are integrated with the RJ-45 connector to indicate management port status. The upper
LED is the Tx/Rx (transmit and receive activity) indicator; the lower LED is the Link indicator, as
shown in
When a link is established, the Link LED appears as a steady green light. When there is activity, the
Link LED appears as a flashing green light.
The Tx/Rx LED appears as a steady green light when lit, which indicates a port speed of
100/1000 Mbps. If the Tx/Rx LED is not lit, port speed is 10 Mbps.
NOTE
Do not attach any devices to the RJ-45 connector other than a compatible cable.
22
Tx/Rx LED
QSFP port LEDs
identifies the SFP+ and QSFP port status LED information.
SFP+ and QSFP port status LEDs
Fault (!) LED
Off
Off
Off
Steady amber
Figure 12.
2 Fault (!) LED
Port status
Offline (no link)
Online (link up)
Active (link activity)
Port fault
IBM Flex System EN4023 10Gb Scalable Switch User's Guide