Table of Contents
Advertisement
Figure 86
Configure and enable call-home event notification
Figure 87
144
SAN32M1 Fabric Switch Installation and Service Manual
Configure Ethernet events dialog box
3. Click the Enable Ethernet Events check box. A check mark appears
in the check box to indicate Ethernet events are enabled.
4. At the Ethernet Timeout field, type a value between 10 through 120
minutes.
5. Click OK to close the dialog box.
Telephone numbers and other information for the call-home feature
are configured through the Windows 2000 dial-up networking
application. Refer to
Task 11: Configure the call-home feature (optional)
for configuration instructions. Refer to
(optional)
on page 152 for instructions on testing this notification
feature.
NOTE: The call-home feature may not be available if the EFC Management
applications (EFCM Lite) is installed on a customer-supplied platform.
1. Close the Hardware View and return to the Products View by
clicking close (X) at the upper right corner of the window.
2. Select Configure Call Home Event Notification from the Maintenance
menu. The Configure Call Home Event Notification dialog box
displays
(Figure
87).
Configure call home event notification dialog box
Task 23: Test remote notification
Advertisement
Table of Contents
