Figure 108
Enable or Disable Host Control
Configure Panel (Management Page with CLI Tab)
2. Perform one of the following steps as required:
• Click Enable to activate the CLI. The message Your changes
to the CLI enable state have been successfully activated
appears.
• Click Disable to deactivate the CLI. The message Your changes
to the CLI enable state have been successfully activated
appears.
Perform this procedure to toggle (enable or disable) host control of
the switch through the OSMS. The OSMS feature must be installed to
access this control. Refer to
instructions. If the feature is not installed, the message OSMS
Feature Not Installed appears. To enable or disable host control:
1. At the Configure panel, click the OSMS tab. The Management page
displays with the OSMS tab selected
Install PFE Keys (Optional)
(Figure
109).
Chapter 2: Installation tasks
on page 184 for
173