Configure Switch Binding
Figure 112
2. Click Activate to save the information. The message Your changes
to the port binding configuration have been successfully
activated appears.
Perform this procedure to configure switch binding by attached
devices (nodes). The SANtegrity™ feature must be installed to access
this control. Refer to
Install PFE Keys (Optional)
instructions. If the feature is not installed, the message This Feature
Not Installed appears. To configure switch binding:
1. At the Configure panel, click the Switch Binding tab. The Security
page displays with the Switch Binding tab selected
Configure Panel (Security Page with Switch Binding Tab)
2. Select the connection policy from the Switch Binding State
drop-down list. The switch binding state indicates the type of
binding restrictions imposed on the switch. Switch binding is
enabled by activating Enterprise Fabric Mode (refer to
Disable Enterprise Fabric Mode
connection policy at the Switch Binding State drop-down list.
Available selections are:
on page 184 for
(Figure
on page 180), or by enforcing a
Chapter 2: Installation tasks
112).
Enable or
177