Figure 109
Configure User Rights
174
SAN32M1 Fabric Switch Installation and Service Manual
Configure Panel (Management Page with OSMS Tab)
2. Perform one of the following steps as required:
• Click Enable to activate the OSMS. The message Your changes
to the host control enable state have been successfully
activated appears.
• Click Disable to deactivate the OSMS. The message Your
changes to the host control enable state have been
successfully activated appears.
Perform this procedure to configure the administrator-level and
operator-level passwords used to access the SANpilot interface
through the Enter Network Password dialog box. To configure
passwords:
1. At the Configure panel, click the Security tab. The Security page
displays with the User Rights tab selected
page 175).
(Figure 110
on