Table of Contents
Advertisement
Figure 100
160
SAN32M1 Fabric Switch Installation and Service Manual
Configure panel (ports page)
a. For each port to be configured, type a port name of 24
alphanumeric characters or less in the associated Name field.
The port name should characterize the device to which the
port is attached.
b. Click a check box in the Blocked column to block or unblock a
port (default is unblocked). A check mark in the box indicates
a port is blocked. Blocking a port prevents the attached device
or fabric switch from communicating. A blocked port
continuously transmits the offline sequence (OLS).
c. Click the check box in the FAN column to enable or disable the
fabric address notification (FAN) feature (default is enabled).
A check mark in the box indicates FAN is enabled. When the
feature is enabled, the port transmits FAN frames after loop
initialization to verify that FC-AL devices are still logged in. It
is recommended this option be enabled for ports configured
for loop operation.
d. Select from the drop-down list in the Type column to configure
the port type. Available selections are:
• Generic mixed port (GX_Port). Use this selection to
configure a port as a generic loop port (GL_Port). This is
the default selection.
Advertisement
Table of Contents
