Table of Contents
Advertisement
Switch binding state change dialog box
Figure 71
2. Perform one of the following steps:
• To disable Switch Binding (when a checkmark appears in the
Enable Switch Binding check box), click the Enable Switch
Binding check box to remove the checkmark, then click
Activate.
• To enable Switch Binding (when there is no checkmark in the
Enable Switch Binding check box), click the Enable Switch
Binding check box to add a checkmark. Go on to step 3 to set
the Connection Policy.
3. Click one of the Connection Policy radio buttons.
• Restrict E_Ports. Select this if you want to restrict connections
from specific switches to switch E_Ports. Switch WWNs can be
added to the Switch Membership List to allow connection and
removed from the Membership List to prohibit connection.
Devices are allowed to connect to any F_Port.
• Restrict F_Ports. Select this if you want to restrict connections
from specific devices to switch F_Ports. Device WWNs can be
added to the Switch Membership List to allow connection and
removed from the Membership List to prohibit connection.
Switches are allowed to connect to any E_Port.
• Restrict All. Select this if you want to restrict connections from
specific devices to switch F_Ports and switches to switch
E_Ports. Device and switch WWNs can be added to the Switch
Membership List to allow connection and removed from the
Membership List to prohibit connection.
4. Click Activate to enable the changes and close the dialog box.
Chapter 2: Installation tasks
115
Advertisement
Table of Contents
