Table of Contents
Advertisement
and asynchronous RS-232 modem cable are required to verify the
reporting of event code 433. Both tools are provided by installation or
service personnel. To verify the event code:
a. Remove the protective cap from the 9-pin maintenance port at
the rear of the switch (a flat-tip screwdriver may be required).
Connect one end of the RS-232 modem cable to the port.
b. Connect the other cable end to a 9-pin communication port
(COM1 or COM2) at the rear of the maintenance terminal PC.
c. Power on the maintenance terminal. After the PC powers on, the
Windows desktop displays.
d. Click the Windows Start button. The Windows Workstation menu
displays.
The following steps describe inspecting event code 433 using
HyperTerminal serial communication software.
e. At the Windows Workstation menu, sequentially select
Programs, Accessories, and HyperTerminal. The Connection
Description dialog box displays.
Connection description dialog box
Figure 147
f. Type SAN32M1 in the Name field and click OK. The Connect To
dialog box displays.
Chapter 3: Diagnostics
253
Advertisement
Table of Contents
