Table of Contents
Advertisement
Task 25: Configure the switch from the SANpilot Interface
(optional)
If an management server is not available, use the SANpilot interface
to configure the switch. Selectively perform the following
configuration tasks according to the customer's installation
requirements:
•
Configure switch ports.
•
Configure the switch identification, date and time, operating
parameters, fabric parameters, and network addresses.
•
Configure SNMP trap message recipients, enable the command
line interface (CLI), and configure the open systems management
server (OSMS) feature.
•
Configure administrator and operator passwords.
•
Install switch product feature enablement (PFE) keys.
Perform procedures under this task to configure the switch from the
SANpilot interface. A PC platform with Internet access and standard
web browser running Netscape Navigator 4.6 or higher or Microsoft
Internet Explorer 4.0 or higher is required.
1. Connect the switch to the Internet or Ethernet LAN segment as
follows:
a. Connect one end of the Ethernet patch cable (supplied with
the switch) to the RJ-45 connector (labelled 10/100) on the left
front of the switch chassis.
b. Connect the remaining end of the Ethernet cable as follows:
• Connect the cable to an Internet port or Internet-connected
LAN segment as directed by the customer's network
administrator, or
• If the Ethernet hub installed in
install the Ethernet hub (optional)
Internet connectivity, connect the cable to any available
hub port.
2. Open the SANpilot interface as follows:
Task 2: Unpack, inspect, and
on page 57 provides
Chapter 2: Installation tasks
157
Advertisement
Table of Contents
