Table of Contents
Advertisement
Figure 78
Switch parameters
Domain ID
c. When the warning box displays asking you to confirm the
offline state, click OK.
2. Select Switch Parameters from the Operating Parameters submenu
(Configure menu tab).
3. The Configure Switch Parameters dialog box displays.
Configure switch parameters dialog box
NOTE: Ordinarily, you do not need to change values in this dialog box from
their defaults. The only exception is the Preferred Domain ID. Change this
value if the switch will participate in a multiswitch fabric.
4. Use information under
required for parameters in this dialog box.
5. After you change settings, click the Activate button.
Configure the following parameters as required by your fabric.
The domain identification is a value between 1 and 31 that provides a
unique identification for the switch in a fabric. A fabric switch cannot
contain the same domain ID as another switch or their E_Ports will
segment when they try to join.
In the Configure Switch Parameters dialog box, a field is provided to
enter a preferred domain ID and a check box is provided to enable
this ID as an insistent domain ID.
Switch parameters
to change settings as
Chapter 2: Installation tasks
129
Advertisement
Table of Contents
