Table of Contents
Advertisement
Figure 139
246
SAN32M1 Fabric Switch Installation and Service Manual
a. Remove the protective cap from the 9-pin maintenance port at
the rear of the switch (a flat-tip screwdriver may be required).
Connect one end of the RS-232 modem cable to the port.
b. Connect the other cable end to a 9-pin communication port
(COM1 or COM2) at the rear of the maintenance terminal PC.
c. Power on the maintenance terminal. After the PC powers on, the
Windows desktop displays.
d. At the Windows desktop, click Click the Windows Start button.
The Windows Workstation menu displays.
The following steps describe inspecting the IP address using
HyperTerminal serial communication software.
e. At the Windows Workstation menu, sequentially selectPrograms,
Accessories, and HyperTerminalHyperTerminal. The Connection
Description dialog box displays.
Connection description dialog box
f. Type IBM TotalStorage SAN32M1 switch in the Name field and
click OK. The Connect To dialog box displays.
Advertisement
Table of Contents
