Disconnecting The Sfp+ Module Cable; Connecting The Rj-45 Cable; Disconnecting The Rj-45 Cable; Locating The Information Panels, Leds, And External Ports - IBM Flex System EN2092 User Manual

2. Gently slide the fiber optic cable into the SFP+ module until it clicks into place.
3. Check the LEDs on the switch. When the switch is operating correctly, the

Disconnecting the SFP+ module cable

To disconnect the SFP+ module cable, complete the following steps.
1. Squeeze the release tabs and gently pull the fiber optic cable from the SFP+
2. Replace the protective caps on the ends of the fiber optic cable.

Connecting the RJ-45 cable

To connect the RJ-45 connector to the switch, push the RJ-45 cable connector into
the port connector until it clicks into place.

Disconnecting the RJ-45 cable

To disconnect the RJ-45 connector, squeeze the release tab and gently pull the
cable connector out of the switch-module connector.
10
EN2092 1 Gb Ethernet Scalable Switch: User's Guide
Fiber-optic
cable
green link LED is lit. For information about the status of the switch LEDs, see
"Locating the information panels, LEDs, and external ports" on page 13.
module.
Protective cap