Connecting The Rj-45 Cable; Disconnecting The Rj-45 Cable; Locating The Information Panels, Leds, And External Ports; Information Panel - IBM EN4093R User Manual

Connecting the RJ-45 cable

The RJ-45 cable can be connected to the external management port.
To connect the RJ-45 connector to the switch, push the RJ-45 cable connector into
the port connector until it clicks into place.

Disconnecting the RJ-45 cable

To disconnect the RJ-45 connector, squeeze the release tab and gently pull the
cable connector out of the switch-module connector.

Locating the information panels, LEDs, and external ports

This section describes the information panels and LEDs on the switch and identifies
the external ports on the information panels.
Note: The illustrations in this document might differ slightly from your hardware.

Information panel

The front panel of the switch contains information LEDs, fourteen SFP+ module port
connectors, two QSFP+ module port connectors, one RS-232 serial port connector,
and one Ethernet port connector.
14
EN4093 and EN4093R 10 Gb Scalable Switch: User's Guide