H3C S7500E Series Operation Manual page 770

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches
# Configure Switch B as a static RPF peer of Switch C.
[SwitchC]
less-equal 32
[SwitchC] msdp
[SwitchC-msdp] peer 192.168.3.2 connect-interface vlan-interface 102
[SwitchC-msdp] static-rpf-peer 192.168.3.2 rp-policy list-c
[SwitchC-msdp] quit
# Configure Switch B as a static RPF peer of Switch E.
[SwitchE]
less-equal 32
[SwitchE] msdp
[SwitchE-msdp] peer 192.168.3.2 connect-interface vlan-interface 102
[SwitchE-msdp] static-rpf-peer 192.168.3.2 rp-policy list-c
[SwitchE-msdp] quit
5) Verify the configuration
Carry out the display bgp peer command to view the BGP peering relationships
between the switches. If the command gives no output information, a BGP peering
relationship has not been established between the switches.
When the multicast source in PIM-SM 1 (Source 1) and the multicast source in PIM-SM
2 (Source 2) send multicast information, receivers in PIM-SM 1 and PIM-SM 3 can
receive the multicast data. You can use the display msdp brief command to view the
brief information of MSDP peering relationships between the switches. For example:
# View the brief MSDP peer information on Switch B.
[SwitchB] display msdp brief
MSDP Peer Brief Information
Configured
2
Peer's Address
192.168.3.2
192.168.1.2
# View the brief MSDP peer information on Switch C.
[SwitchC] display msdp brief
MSDP Peer Brief Information
Configured
1
Peer's Address
192.168.1.1
# View the brief MSDP peer information on Switch E.
ip ip-prefix list-c
ip ip-prefix list-c
Up Listen
2 0
State Up/Down time
Up 01:07:08
Up 00:16:39
Up Listen
1 0
State Up/Down time
Up 01:07:09
permit 192.168.0.0
permit 192.168.0.0
Connect
0
AS
?
?
Connect
0
AS
?
6-26
Chapter 6 MSDP Configuration
16 greater-equal
16 greater-equal
Shutdown Down
0 0
SA Count Reset Count
8 0
13 0
Shutdown Down
0 0
SA Count Reset Count
8 0
16
16