H3C S7500E Series Operation Manual page 661

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches
II. Network diagram
Source
1.1.1.1/24
Figure 2-4 Network diagram for static router port configuration
III. Configuration procedure
1) Configure the IP address of each interface
Configure an IP address and subnet mask for each interface as per
detailed configuration steps are omitted.
2) Configure Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
Ethernet 1/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/0/1
[RouterA-Ethernet1/0/1] igmp enable
[RouterA-Ethernet1/0/1] pim dm
[RouterA-Ethernet1/0/1] quit
[RouterA] interface ethernet 1/0/2
[RouterA-Ethernet1/0/2] pim dm
[RouterA-Ethernet1/0/2] quit
3) Configure Switch A
# Enable IGMP Snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
Eth1/0/2 Eth1/0/1
1.1.1.2/24 10.1.1.1/24
Router A
IGMP querier
Switch C
Eth2/0/5
Host C
Receiver
Host B
Chapter 2 IGMP Snooping Configuration
Switch A
Eth2/0/1
Eth2/0/2 Eth2/0/2
Host A
Receiver
2-27
Switch B
Figure 2-4. The