Ospfv3 Configuration Examples; Configuring Ospfv3 Areas - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Display OSPFv3 link state
request list information
Display OSPFv3 link state
retransmission list
information
Display OSPFv3 statistics

3.8 OSPFv3 Configuration Examples

3.8.1 Configuring OSPFv3 Areas

I. Network requirements
In the following figure, all switches run OSPFv3. The AS is split into three areas, in
which, Switch B and Switch C act as ABRs to forward routing information between
areas.
It is required to configure Area 2 as a stub area, reducing LSAs into the area without
affecting route reachability.
II. Network diagram
Figure 3-2 Network diagram for OSPFv3 area configuration
III. Configuration procedure
1) Configure IPv6 addresses for interfaces (omitted)
2) Configure OSPFv3 basic functions
# Configure Switch A.
To do...
display ospfv3 [ process-id ] request-list
[ { external | inter-prefix | inter-router |
intra-prefix | link | network | router }
[ link-state-id ] [ originate-router
ip-address ] | statistics ]
display ospfv3 [ process-id ] retrans-list
[ { external | inter-prefix | inter-router |
intra-prefix | link | network | router }
[ link-state-id ] [ originate-router
ip-address ] | statistics ]
display ospfv3 statistic
Chapter 3 IPv6 OSPFv3 Configuration
Use the command...
3-14
Remarks