H3C S7500E Series Operation Manual page 1242

Operation Manual – HA
H3C S7500E Series Ethernet Switches
[SwitchA-Vlan-interface2] ip address 202.38.160.1 255.255.255.0
# Create standby group 1 and set its virtual IP address to be 202.38.160.111.
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Set the priority of Switch A in standby group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Set Switch A to work in preemption mode. The preemption delay is five seconds.
[SwitchA-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
2) Configure Switch B
# Configure VLAN 2.
<SwitchB> system-view
[SwitchB] vlan 2
[SwitchB-Vlan2] port GigabitEthernet 2/0/5
[SwitchB-vlan2] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0
# Create standby group 1 and set its virtual IP address to be 202.38.160.111.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Set Switch B to work in preemption mode. The preemption delay is five seconds.
[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
3) Verify the configuration
After the configuration, Host B can be pinged through on Host A. You can use the
display vrrp verbose command to verify the configuration.
# Display detailed information of standby group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
# Display detailed information of standby group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: NONE
: 202.38.160.111
: 0000-5e00-0101
: 202.38.160.1
1-21
Chapter 1 VRRP Configuration
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 5