Operation Manual – QoS
H3C S7500E Series Ethernet Switches
To do...
Enter system view
Enter port
view or
port
group
view
Configure port
priority
5.3.3 Configuration Examples
I. Network requirements
Configure the port priority to 7.
II. Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure port priority of Ethernet2/0/1.
[Sysname] interface Ethernet 2/0/1
[Sysname-Ethernet2/0/1] qos priority 7
5.4 Configuring Port Priority Trust Mode
You can configure the switch to trust the DSCP precedence of the received packets. In
this case, the switch searches the dscp-dot1p/dp/dscp mapping table for the
corresponding precedence according to the DSCP precedence of the packets and
marks the received packets with the precedence.
5.4.1 Configuration Prerequisites
It is determined to trust the DSCP precedence of received packets.
5.4.2 Configuration Procedure
Follow these steps to configure the port priority trust mode:
Use the command...
system-view
Enter
interface interface-type
port
interface-number
view
Enter
port-group { manual
port
port-group-name |
group
aggregation agg-id }
view
qos priority priority-value
5-5
Chapter 5 Priority Mapping
Remarks
—
Perform either of the two
operations.
The configuration performed in
Ethernet port view applies to
the current port only. The
configuration performed in port
group view applies to all the
ports in the port group.
Required
By default, the port priority is 0.