Ipv6 Bgp Configuration Examples; Ipv6 Bgp Basic Configuration - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches

5.9 IPv6 BGP Configuration Examples

Note:
Some examples for IPv6 BGP configuration are similar to those of BGP-4, so refer to
the sections covering BGP in the IPv4 routing part for related information.

5.9.1 IPv6 BGP Basic Configuration

I. Network requirements
In the following figure are all IPv6 BGP switches. Between Switch A and Switch B is an
EBGP connection. Switch B, Switch C and Switch D are IBGP fully meshed.
II. Network diagram
Figure 5-1 IPv6 BGP basic configuration network diagram
III. Configuration procedure
1) Configure IPv6 addresses for interfaces (omitted)
2) Configure IBGP connections
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] bgp 65009
[SwitchB-bgp] router-id 2.2.2.2
[SwitchB-bgp] ipv6-family
[SwitchB-bgp-af-ipv6] peer 9:1::2 as-number 65009
[SwitchB-bgp-af-ipv6] peer 9:3::2 as-number 65009
[SwitchB-bgp-af-ipv6] quit
[SwitchB-bgp] quit
Chapter 5 IPv6 BGP Configuration
5-23