Configuring Ipv6 Bgp Soft Reset - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Enter system view
Enter BGP view
Enter IPv6 address family
view
Configure
IPv6 BGP
timers
Configure the interval for
sending the same update to
a peer/peer group
Note:
Timers configured using the timer command have lower priority than timers
configured using the peer timer command.
The holdtime interval must be at least three times the keepalive interval.

5.6.3 Configuring IPv6 BGP Soft Reset

I. Enable route refresh
Follow these steps to enable route refresh:
To do...
Enter system view
Enter BGP view
Enter IPv6 address
family view
To do...
system-view
bgp as-number
ipv6-family
Specify
keepalive
timer keepalive
interval and
keepalive hold holdtime
holdtime
Configure
keepalive peer { ipv6-group-name |
interval and ipv6-address } timer
holdtime for a
keepalive keepalive hold
peer/peer
holdtime
group
peer { ipv6-group-name |
ipv6-address }
route-update-interval
seconds
system-view
bgp as-number
ipv6-family
Chapter 5 IPv6 BGP Configuration
Use the command...
Use the command...
5-15
Remarks
—
Required
—
Optional
The keepalive interval
defaults to 60 seconds,
holdtime defaults to 180
seconds.
Optional
The interval for sending
the same update to an
IBGP peer or an EBGP
peer defaults to 15
seconds or 30 seconds
Remarks
—
Required
—