Configuring Ipv6 Is-Is Basic Functions - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches

4.2 Configuring IPv6 IS-IS Basic Functions

Note:
You can implement IPv6 inter-networking through configuring IPv6 IS-IS in IPv6
network environment.
4.2.1 Configuration Prerequisites
Before the configuration, accomplish the following tasks first:
Enable IPv6 globally
Configure IP addresses for interfaces, and make sure all neighboring nodes are
reachable.
Enable IS-IS
4.2.2 Configuration Procedure
Follow these steps to configure the basic functions of IPv6 IS-IS:
Enter system view
Enable an IS-IS process
and enter IS-IS view
Configure the network
entity title for the IS-IS
process
Enable IPv6 for the IS-IS
process
Return to system view
Enter interface view
Enable IPv6 for an IS-IS
process on the interface
To do...
system-view
isis [ process-id ]
network-entity net
ipv6 enable
quit
interface interface-type
interface-number
isis ipv6 enable
[ process-id ]
Chapter 4 IPv6 IS-IS Configuration
Use command to...
4-2
Remarks
––
Required
Not enabled by default
Required
Not configured by default
Required
Disabled by default
––
––
Required
Disabled by default