H3C S7500E Series Operation Manual page 1146

Operation Manual – File System Management
H3C S7500E Series Ethernet Switches
The source address specified with the ftp client source command is valid for all ftp
connections and the source address specified with the ftp command is valid only for the
current FTP connection.
Follow these steps to establish an FTP connection (In IPv4 networking):
Enter system view
Configure the source
address of the FTP
client
Exit to system view
Log onto the remote
FTP server directly in
user view
Log onto the remote
FTP server indirectly in
FTP client view
Note:
If no primary IP address is configured on the source interface, the FTP connection
fails.
If you use the ftp client source command to first configure the source interface and
then the source IP address of the transmitted packets, the new source IP address
will overwrite the current one, and vice versa.
Follow these steps to establish an FTP connection (In IPv6 networking):
To do...
system-view
ftp client source { interface
interface-type
interface-number | ip
source-ip-address }
quit
ftp [ server-address
[ service-port ] [ source
{ interface interface-type
interface-number | ip
source-ip-address } ] ]
ftp
open server-address
[ service-port ]
Use the command...
2-3
Chapter 2 FTP Configuration
Remarks
—
Optional
A device uses the IP
address of the interface
determined by the routing
protocol as the source IP
address to communicate
with the FTP server by
default.
—
Use either approach.
Available in user view