H3C S7500E Series Operation Manual page 1338

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches
Figure 1-7 Networking diagram for single-domain intersecting rings configuration
II. Configuration considerations
First, determine the primary ring and subring in an RRPP domain, node mode of a
device on each RRPP ring, and then perform the following configuration on a
per-device basis:
Create an RRPP domain.
Specify the control VLAN for the RRPP domain.
Specify the node mode of a device on an RRPP ring and the ports accessing the
RRPP ring on the device.
Enable these two RRPP rings.
Enable RRPP
III. Configuration procedure
1) Perform the following configuration on Device A:
<Device A> system-view
[DeviceA] interface gigabitethernet 3/0/1
[DeviceA-GigabitEthernet3/0/1] link-delay 0
[DeviceA-GigabitEthernet3/0/1] quit
[DeviceA] interface gigabitethernet 3/0/2
[DeviceA-GigabitEthernet3/0/2] link-delay 0
[DeviceA-GigabitEthernet3/0/2] quit
[Device A] rrpp domain 1
[Device A-rrpp-domain1] control-vlan 4092
[Device A-rrpp-domain1] ring 1 node-mode master primary-port gigabitethernet
3/0/1 secondary-port gigabitethernet 3/0/2 level 0
[Device A-rrpp-domain1] ring 1 enable
[Device A-rrpp-domain1] quit
1-20
Chapter 1 RRPP Configuration