H3C S7500E Series Operation Manual page 794

Operation Manual – Multicast
H3C S7500E Series Ethernet Switches
[SwitchC] interface vlan-interface 300
[SwitchC-Vlan-interface300] pim dm
[SwitchC-Vlan-interface300] quit
[SwitchC] interface vlan-interface 102
[SwitchC-Vlan-interface102] pim dm
[SwitchC-Vlan-interface102] quit
The configuration on Switch B is similar to that on Switch A. The specific configuration
steps are omitted here.
# Use the display multicast rpf-info command to view the RPF routes to Source 2 on
Switch B and Switch C.
[SwitchB] display multicast rpf-info 50.1.1.100
[SwitchC] display multicast rpf-info 50.1.1.100
No information is displayed. This means that no RPF route to Source 2 exists on Switch
B and Switch C.
3) Configure a multicast static route
# Configure a multicast static route on Switch B, specifying Switch A as its RPF
neighbor on the route to Source 2.
[SwitchB] ip rpf-route-static 50.1.1.100 24 30.1.1.2
# Configure a multicast static route on Switch C, specifying Switch B as its RPF
neighbor on the route to Source 2.
[SwitchC] ip rpf-route-static 50.1.1.100 24 20.1.1.2
4) Verify the configuration
# Use the display multicast rpf-info command to view the RPF routes to Source 2 on
Switch B and Switch C.
[SwitchB] display multicast rpf-info 50.1.1.100
RPF information about source 50.1.1.100:
RPF interface: Vlan-interface102, RPF neighbor: 30.1.1.2
Referenced route/mask: 50.1.1.0/24
Referenced route type: multicast static
Route selection rule: preference-preferred
Load splitting rule: disable
[SwitchC] display multicast rpf-info 50.1.1.100
RPF information about source 50.1.1.100:
RPF interface: Vlan-interface101, RPF neighbor: 20.1.1.2
Referenced route/mask: 50.1.1.0/24
Referenced route type: multicast static
Route selection rule: preference-preferred
Load splitting rule: disable
Chapter 7 Multicast Routing and Forwarding
7-16
Configuration