Configuring The Device Name; Configuring The System Clock - H3C S7500E Series Operation Manual

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches

1.1.2 Configuring the Device Name

To do...
Enter system view
Configure the
device name

1.1.3 Configuring the System Clock

I. Configuring the system clock
Follow these steps to configure the system clock:
To do...
Set time and date
Set the time zone
Set a summer time
scheme
II. Displaying the system clock
The system clock is displayed by system time stamp, which is the same as that
displayed by the display clock command. The system clock is decided by the
commands clock datetime, clock timezone and clock summer-time. If these three
commands are not configured, the display clock command displays the original
system clock. If you combine these three commands in different ways, the system clock
is displayed in the ways shown in
configuration column are as follows:
1 indicates date-time has been configured with the clock datetime.
2 indicates time-zone has been configured with the clock timezone command
and the offset time is zone-offset.
3 indicates summer time has been configured with the clock summer-time
command and the offset time is summer-offset.
[1] indicates the clock datetime command is an optional configuration.
The default system clock is 2005/1/1 1:00:00 in the example.
Use the command...
system-view
sysname sysname
Use the command...
clock datetime time date
clock timezone zone-name { add | minus }
zone-offset
clock summer-time zone-name one-off
start-time start-date end-time end-date add-time
clock summer-time zone-name repeating
start-time start-date end-time end-date add-time
Table 1-1. The meanings of the parameters in the
1-2
Chapter 1 Basic Configurations
Remarks
—
Optional
The device name is H3C by default.
Remarks
Optional
Available
in user
view.