Configuring Edge Node; Configuration Procedure - H3C S7500E Series Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches
Specify the device as the transit node of primary ring 1 in RRPP domain 1,
GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the
secondary port.
II. Configuration procedure
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] link-delay 0
[Sysname-GigabitEthernet3/0/1] quit
[Sysname] interface gigabitethernet 3/0/2
[Sysname-GigabitEthernet3/0/2] link-delay 0
[Sysname-GigabitEthernet3/0/2] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet
3/0/1 secondary-port gigabitethernet 3/0/2 level 0
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable

1.5 Configuring Edge Node

1.5.1 Configuration Procedure

Follow these steps to configure edge node:
Enter system view
Create an RRPP domain
and enter its view
Specify a control VLAN for
the RRPP domain
Specify the current device
as the transit node of the
primary ring, and specify
the primary port and the
secondary port
Specify the current device
as the edge node of a
subring, and specify the
common port and the
edge port
To do...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
ring ring-id node-mode
edge [ common-port
interface-type
interface-number ]
[ edge-port interface-type
interface-number ]
Use the command...
1-12
Chapter 1 RRPP Configuration
Remarks
—
Required
Required
Required
Required