Displaying And Maintaining Tunneling Configuration; Troubleshooting Tunneling Configuration - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
C:\>ipv6 if 2
Interface 2: Automatic Tunneling Pseudo-Interface
Guid {48FCE3FC-EC30-E50E-F1A7-71172AEEE3AE}
does not use Neighbor Discovery
uses Router Discovery
routing preference 1
EUI-64 embedded IPv4 address: 2.1.1.2
router link-layer address: 2.1.1.1
preferred
(public)
preferred link-local fe80::5efe:2.1.1.2, life infinite
link MTU 1500 (true link MTU 65515)
current hop limit 255
reachable time 42500ms (base 30000ms)
retransmission interval 1000ms
DAD transmits 0
default site prefix length 48
# By comparison, it is found that the host acquires the address prefix 2001::/64 and
automatically generates the address 2001::5efe:2.1.1.2. Meanwhile, "uses Switch
Discovery" is displayed, indicating that the switch discovery function is enabled on the
host. At this time, ping the IPv6 address of the tunnel interface of the switch. If the
address is successfully pinged, an ISATAP tunnel is established.
IV. Configuration verification
After the above configurations, the ISATAP host can access the host in the IPV6
network.

3.6 Displaying and Maintaining Tunneling Configuration

Display information about a
specified tunnel interface
Display IPv6 information
related to a specified tunnel
interface

3.7 Troubleshooting Tunneling Configuration

Symptom: After the configuration of related parameters such as tunnel source address,
tunnel destination address, and tunnel type, the tunnel interface is still not up.
Solution: Follow the steps below:
global 2001::5efe:2.1.1.2,
To do...
display interface tunnel
[ number ]
display ipv6 interface
tunnel number
Chapter 3 Tunneling Configuration
life
Use the command...
3-19
29d23h59m46s/6d23h59m46s
Remarks
Available in any view
Available in any view