Master Node Configuration Example - H3C S7500E Series Operation Manual

Operation Manual – RRPP
H3C S7500E Series Ethernet Switches
Enable RRPP
Caution:
The control VLAN configured for an RRPP domain must be a new one.
Control VLAN configuration is required for configuring an RRPP ring.
To use the undo rrpp domain command to remove an RRPP domain, you must
ensure the RRPP domain has no RRPP ring.

1.3.2 Master Node Configuration Example

I. Network requirements
Specify the device in RRPP domain 1;
Set VLAN 4092 as the control VLAN;
Specify the device as the master node of primary ring 1 in RRPP domain 1,
GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the
secondary port;
Set the Hello timer value to 2 seconds and the Fail timer value to 7 seconds.
II. Configuration procedure
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] link-delay 0
[Sysname-GigabitEthernet3/0/1] quit
[Sysname] interface gigabitethernet 3/0/2
[Sysname-GigabitEthernet3/0/2] link-delay 0
[Sysname-GigabitEthernet3/0/2] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode master primary-port gigabitethernet
3/0/1 secondary-port gigabitethernet 3/0/2 level 0
[Sysname-rrpp-domain1] timer hello-timer 2 fail-timer 7
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable
To do...
rrpp enable
Use the command...
1-10
Chapter 1 RRPP Configuration
Remarks
Required
By default, RRPP is
disabled.