Pass Through - H3C S7500E Series Operation Manual

Operation Manual – QoS
H3C S7500E Series Ethernet Switches
[SwitchA-classifier-c55] traffic classifier c66
[SwitchA-classifier-c66] if-match service-vlan-id 302
[SwitchA-classifier-c66] quit
[SwitchA] traffic behavior b11
[SwitchA-behavior-b11] remark customer-vlan-id 1
[SwitchA-behavior-b11] traffic behavior b22
[SwitchA-behavior-b22] remark customer-vlan-id 2
[SwitchA-behavior-b22] traffic behavior b33
[SwitchA-behavior-b33] remark customer-vlan-id 3
[SwitchA-behavior-b33] quit
[SwitchA] qos policy p11
[SwitchA-policy-p11] classifier c11 behavior b11
[SwitchA-policy-p11] classifier c22 behavior b22
[SwitchA-policy-p11] classifier c33 behavior b33
[SwitchA-policy-p11] quit
[SwitchA] qos policy p22
[SwitchA-policy-p22] classifier c44 behavior b11
[SwitchA-policy-p22] classifier c55 behavior b22
[SwitchA-policy-p22] classifier c66 behavior b33
[SwitchA-policy-p22] quit
# Configure GigabitEthernet 2/0/1 to permit packets of SVLANs 101, 201, and 301 to

pass through.

[SwitchA] interface GigabitEthernet 2/0/1
[SwitchA-GigabitEthernet2/0/1] port link-type trunk
[SwitchA-GigabitEthernet2/0/1] port trunk permit vlan 101 201 301
# Enable basic QinQ on GigabitEthernet 2/0/1.
[SwitchA-GigabitEthernet2/0/1] qinq enable
# Apply the uplink policy p1 to the inbound direction of GigabitEthernet 2/0/1.
[SwitchA-GigabitEthernet2/0/1] qos apply policy p1 inbound
# Apply the downlink policy p11 to the outbound direction of GigabitEthernet 2/0/1.
[SwitchA-GigabitEthernet2/0/1] qos apply policy p11 outbound
[SwitchA-GigabitEthernet2/0/1] quit
# Configure GigabitEthernet 2/0/2 to permit packets of SVLANs 102, 202, and 302 to
pass through.
[SwitchA] interface GigabitEthernet 2/0/2
[SwitchA-GigabitEthernet2/0/2] port link-type trunk
[SwitchA-GigabitEthernet2/0/2] port trunk permit vlan 102 202 302
# Enable basic QinQ on GigabitEthernet 2/0/2.
[SwitchA-GigabitEthernet2/0/2] qinq enable
Chapter 7 VLAN Mapping Configuration
7-8