Displaying And Maintaining Ripng; Ripng Configuration Example; Configuring The Maximum Number Of Equal Cost Routes For Load Balancing - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
2.4.4 Configuring the Maximum Number of Equal Cost Routes for Load
Balancing
Follow these steps to configure the maximum number of equal cost RIPng routes for
load balancing:
Enter system view
Enter RIPng view
Configure the maximum number of
equal cost RIPng routes for load
balancing

2.5 Displaying and Maintaining RIPng

Display configuration
information of a RIPng process
Display routes in the RIPng
database
Display the routing information
of a specified RIPng process
Display RIPng interface
information

2.6 RIPng Configuration Example

I. Network requirements
As shown in
(3::/64) learnt from Switch C, which means the route will not be added to the routing
table of Switch B, and Switch B will not forward it to Switch A.
II. Network diagram
Figure 2-4 Network diagram for RIPng configuration
To do...
To do...
Figure 2-4, all switches run RIPng. Configure Switch B to filter the route
2-10
Chapter 2 IPv6 RIPng Configuration
Use the command...
system-view
ripng [ process-id ]
maximum
load-balancing number
Use the command...
display ripng
[ process-id ]
display ripng process-id
database
display ripng process-id
route
display ripng process-id
interface [ interface-type
interface-number ]
Remarks
––
––
Optional
4 by default
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in any
view